期刊


ISSN1059-9495
刊名Journal of Materials Engineering and Performance
参考译名材料工程与特性杂志
收藏年代1998～2024



全部

1998 1999 2000 2001 2002 2003
2004 2005 2006 2007 2008 2009
2010 2011 2012 2013 2014 2015
2016 2017 2018 2019 2020 2021
2022 2023 2024

2001, vol.10, no.1 2001, vol.10, no.2 2001, vol.10, no.3 2001, vol.10, no.4 2001, vol.10, no.5 2001, vol.10, no.6

题名作者出版年年卷期
Effects of surface preparation on pitting resistance, residual stress, and stress corrosion cracking in austenitic stainless steelsA. Ben Rhouma; C. Braham; M. E. Fitzpatrick; J. Ledion; H. Sidhom20012001, vol.10, no.5
Microstructural modification in a laser-treated 2.25Cr-1Mo steelR. V. Subba Rao; P. Parameswaran; R. K. Dayal20012001, vol.10, no.5
The effect of graphite particles addition on the surface finish of machined Al-4 wt.% Mg alloysMohammed T. Hayajneh; Adel Mahammod Hassan; Mohammad Abdul-Hameed Al-Omari20012001, vol.10, no.5
Effects of cooling time and alloying elements on the microstructure of the Gleeble-simulated heat-affected zone of 22% Cr duplex stainless steelsRong-Iuan Hsieh; Horng-Yih Liou; Yeong-Tsuen Pan20012001, vol.10, no.5
Improvement of the wear resistance of Ti-based coating sliding against copper alloyW. H. Kao20012001, vol.10, no.5
Elect of oxide additives and particle size on stabilization of treated commercial zirconiaMaham Yasmeen; Syed Asif Ansar; Amir Azam Khan; Thierry Joyeux; Jean Claude Labbe20012001, vol.10, no.5
Low cost corrosion damage mitigation and improved fatigue performance of low plasticity burnished 7075-T6Paul S. Prevey; John Cammett20012001, vol.10, no.5
Structure-property correlation of two Cu-bearing high-strength low-alloy steelsT. B. Bini; D. Kanchanamala; K. J. L. Iyer; S. Sundaresan; V. M. Radhakrishnan20012001, vol.10, no.5
Kinetics of strain aging in bake hardening ultra low carbon steel-- a comparison with low carbon steelA. K. De; S. Vandeputte; B. C. De Cooman20012001, vol.10, no.5
Fracture toughness properties of high-strength martensitic steel within a wide hardness rangeN. M. Abd-Allah; M. S. El-Fadaly; M. M. Megahed; A. M. Eleiche20012001, vol.10, no.5
12



制造业外文文献服务平台