期刊


ISSN0944-6524
刊名Production Engineering
参考译名生产工程
收藏年代2008～2023



全部

2008 2009 2010 2011 2012 2013
2014 2015 2016 2017 2018 2019
2020 2021 2022 2023

2012, vol.6, no.1 2012, vol.6, no.2 2012, vol.6, no.3 2012, vol.6, no.4/5 2012, vol.6, no.6

题名作者出版年年卷期
Influence of the cutting edge rounding on the chip formation process: Part 1. Investigation of material flow, process forces, and cutting temperatureB. Denkena; J. Kohler; Mesfin Sisay Mengesha20122012, vol.6, no.4/5
Development of a warm cross wedge rolling process using FEA and downsized experimental trialsHanns Kache; Malte Stonis; Bernd-Arno Behrens20122012, vol.6, no.4/5
A new experimental methodology to analyse the friction behaviour at the tool-chip interface in metal cuttingHendrik Puls; Fritz Klocke; Dieter Lung20122012, vol.6, no.4/5
Process design space for optimal surface integrity in finish hard milling of tool steelS. Zhang; W. Li; Y. B. Guo20122012, vol.6, no.4/5
Residual stresses in surface layer after dry and MQL turning of AISI 316L steelTadeusz Leppert; Ru Lin Peng20122012, vol.6, no.4/5
Determination of surface and in-depth residual stress distributions induced by hard milling of H13 steelS. Zhang; T. C. Ding; J. F. Li20122012, vol.6, no.4/5
The non-hydrostatic response of polymer melts as a pressure medium in sheet metal formingA. E. Tekkaya; M. M. Hussain; J. Witulski20122012, vol.6, no.4/5
Simulation of personnel requirements during production ramp-upGisela Lanza; Anna Sauer20122012, vol.6, no.4/5
Flank milling of compliant workpieces with chamfered toolsB. Denkena; W. Bickel; V. Sellmeier20122012, vol.6, no.4/5
Shear cutting of press hardened steel: influence of punch chamfer on process forces, tool stresses and sheared edge qualitiesKatrin Nothhaft; Joungsik Suh; Matthias Golle; Ingrid Picas; Daniel Casellas; Wolfram Volk20122012, vol.6, no.4/5
123



制造业外文文献服务平台